These were both printed on my 3D printer this morning. Same feed rate, same plastic, same temperature, same nozzle diameter.
So when the one on the left started coming out “weird” I thought the printer must be broken somehow.
What I finally realized happened, is that I had changed the nozzles recently. From the .3mm one to the .7mm one. The part on the right was printed with the larger nozzle and printed fine. But after that print I went back and changed some of the settings in the slicer and created another gcode file. It set the nozzle back to the .3mm setting and gave me the part on the left by only extruding half the plastic it should have.
Moral of the story? Double check ALL your settings if something looks wrong. 😀
You must be logged in to post a comment.
S | M | T | W | T | F | S |
---|---|---|---|---|---|---|
1 | 2 | |||||
3 | 4 | 5 | 6 | 7 | 8 | 9 |
10 | 11 | 12 | 13 | 14 | 15 | 16 |
17 | 18 | 19 | 20 | 21 | 22 | 23 |
24 | 25 | 26 | 27 | 28 | 29 | 30 |
31 |
37 queries. 0.050 seconds